Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conversion Table Standardized Diagnostic Trouble Codes (DTCS)/VOLVO Diagnostic Trouble Codes (DTCS): Information
Background
OBD II is a diagnostics system designed to meet statutory requirements. A standardized instrument for fault-tracing can be plugged in to the data link connector (DLC) (OBD II socket) to read diagnostic trouble codes (DTCs) and system parameters. OBD II contains only emissions related diagnostic trouble codes (DTCs) and parameters. It cannot provide the comprehensive range of information available from the Volvo On-board diagnostics system.
Volvo has its own diagnostic trouble code (DTC) designations that adhere to the in-house Volvo On-board Diagnostics protocol (called DII from model year 1999).
Table explanations
The table below is a conversion table between standardized diagnostic trouble codes (DTCs) (SAE/ISO) and the equivalent Volvo diagnostic trouble codes (DTCs) (DII).
SAE/ISO DTC: Standardized diagnostic trouble code as per SAE J2012/ISO 15031-6. The DTC can be read out from the vehicle using a standardized diagnostics system for emission-related faults certified as per OBD II. The readout is taken with a generic scan tool, a fault tracing instrument standardized as per SAE J1978/ISO 15031-4.
Volvo DII DTC: Volvo-specific diagnostic trouble code as per Volvo Onboard Diagnostics protocol. Can be read out using VIDA in vehicles from model year 1999.
DTC designation: Volvo DTC designation. Used in VIDA.
Fault type: Volvo's method of specifying the fault. Used in VIDA.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
