Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Signals For Control Modules Without DSTC
The table below summarizes the input signals to and output signals from the brake control module (BCM). The signal types are divided into directly connected signals, serial communication and controller area network (CAN) communication. The illustration below displays the same information with the Volvo component designations.
| Input signals | Output signals |
| Directly connected: | Directly connected: |
| Four Wheel sensors
(7/31, 7/32, 7/56, 7/57) Pedal position sensor (7/124) |
-- |
| Via Controller Area Network (CAN) communication: | Via Controller Area Network (CAN) communication: |
| Central electronic module (CEM)
(4/56). Provides information about the car configuration. Transmission control module (TCM) (4/28): Provides information about the present gear, next gear and lock-up status (automatic transmission only). Engine control module (ECM) (4/46):
Climate control module (CCM) (3/112). Provides information about activation/deactivation of stability control via the STC switch on the tunnel console. Differential electronic module (DEM) (4/82). Indicates the torque distribution to the rear wheels and the function status (TRACS AWD only). |
Driver information module (DIM)
(5/1):
Transmission control module (TCM) (4/28):
Engine control module (ECM) (4/46):
Infotainment control module (ICM) (16/1):
Differential electronic module (DEM) (4/82). Receives information about the brake function (TRACS AWD only). |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
