2011 Volvo S40 T-5 R-DesignFACTORY OEM SERVICE PROCEDURE

Control Module

Fig 1: Identifying AM/FM Tuner Module (AFM)
GLL117585Courtesy of VOLVO CARS OF NORTH AMERICA.

The AM/FM tuner module (AFM) has the task of receiving radio signals on the AM or FM wavebands then processing and transmitting the signals onwards on the MOST network.

There are four different market configurations:

  • Europe
  • USA
  • Australia
  • Japan.

In 4-door vehicles the control module is located on the parcel shelf. In 5-door vehicles the control module is located under the right-hand rear side window.

The control module uses optical serial communication to communicate with other components on the MOST network. This means that all communication with the control module is via the infotainment control module (ICM).

Any diagnostic trouble codes (DTCs) are stored in the control module memory. This information can be read off using VIDA via the data link connector (DLC) in the vehicle.

For further information, also, see SIGNALSΒ .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.