Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code (DTC) Information Bpm-1106
Condition
Bluetooth phone module (BPM) checks its internal temperature.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The temperature is too high.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on and battery voltage between 9 and 16 V.
Substitute Value
- None.
Possible Source
- Ambient temperature too high.
- Power consumption too high in the control module.
Fault symptom[s]
- Bluetooth Telephone: No Functionality
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.