Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Volvo C30 R-Design, AutomaticFACTORY OEM SERVICE PROCEDURE
Signal Specification
All values contained below are between the relevant terminal and signal ground, unless otherwise indicated in brackets.
NOTE:
It is important to connect the breakout box and check the ground terminals before taking readings.
| U= | DC voltage in volts (V) | UAC = | AC voltage in volts (V) |
| Ubat = | Battery voltage (V) | f = | Frequency in Hertz (Hz) |
| Ulow = | Voltage approximately 0 V | t = | Time in seconds (s) |
SIGNAL TABLE CONNECTOR A
| Control module terminal | Breakout box terminal | Signal type | Ignition on |
|---|---|---|---|
| #A1 | #1 | - | - |
| #A2 | #2 | Signal malfunction indicator lamp (MIL) | Lamp off: U = Ubat Lamp on: U = Ulow |
| #A3 | #3 | Power supply Extended X | U = Ubat |
| #A4 | #10 | Signal ground | U = Ulow |
| #A5 | #9 | - | - |
| #A6 | #8 | - | - |
| #A7 | #7 | - | - |
| #A8 | #6 | - | - |
| #A9 | #5 | Control modules communication cable (CAN L) | U = 1.5-2.5 V |
| #A10 | #4 | Control modules communication cable (CAN H) | U = 2.5-3.5 V |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
