Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Volvo C30 R-Design, AutomaticFACTORY OEM SERVICE PROCEDURE
Driver Door Module (DDM) DTCS
DRIVER DOOR MODULE (DDM) - DTC INDEX
| Volvo Code | Description |
|---|---|
| DDM-0012 | Control, driver's window. Stuck in the active position |
| DDM-0013 | Control, passenger window. Stuck in the active position |
| DDM-0020 | Control, door mirror. Stuck in the active position |
| DDM-0022 | Control, door mirror selector. Stuck in the active position |
| DDM-0024 | Central locking switch. Faulty signal |
| DDM-0025 | LED, camera module Signal too low |
| DDM-0026 | LED, camera module Signal too high |
| DDM-0027 | LED, camera module Open circuit |
| DDM-002B | Camera module Internal failure |
| DDM-002F | Camera module voltage supply Signal too low |
| DDM-003A | Camera module voltage supply Signal too high |
| DDM-6E01 | Mirror motor. Shorted to supply |
| DDM-6E02 | Mirror motor. Ground (GND) short |
| DDM-6E03 | Mirror motor. Open circuit |
| DDM-6E04 | Mirror motor. Shorted to supply |
| DDM-6E05 | Mirror motor. Ground (GND) short |
| DDM-6E06 | Mirror motor. Open circuit |
| DDM-6E07 | Mirror motor. Shorted to supply |
| DDM-6E08 | Mirror motor. Ground (GND) short |
| DDM-6E09 | Mirror motor. Open circuit |
| DDM-8002 | Mirror heater. Ground (GND) short |
| DDM-8003 | Mirror heater. Shorted to supply |
| DDM-8021 | Side turn indicator. Ground (GND) short |
| DDM-8022 | Side turn indicator. Open circuit |
| DDM-DD11 | Communication with switch pack Internal Fault |
| DDM-DD20 | LIN communication camera module Internal fault |
| DDM-DD21 | LIN communication camera module Shorted |
| DDM-DD22 | LIN communication camera module Internal fault |
| DDM-DD30 | Communication with camera module Internal Fault |
| DDM-E001 | Control module communication. Faulty communication |
| DDM-XXXX | Unknown diagnostic trouble code (DTC) for the current control module version |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.