2010 Volvo V70 Base, 3.2 96FACTORY OEM SERVICE PROCEDURE

Programming Remote Keys

Remote keys can be added and erased. When programming remote keys for a vehicle, the transponder and remote control are programmed at the same time. A maximum of 6 transponder IDs and their remote control keys can be programmed into the vehicle. The transponder and remote control IDs are stored in the central electronic module (CEM) in cars without the keyless locking system.

In cars with the keyless locking system, only the transponder ID is stored in the central electronic module (CEM). ID of the keyless function is stored in the keyless vehicle module (KVM) and also saved in the Central electronic module (CEM).

The erase function is used when the customer wishes to prevent one or more remote keys from being used to start the vehicle. The remote keys may have been stolen and could be traced back to the vehicle.

Remote keys are programmed via the Software Manager.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.