Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Codes (DTCS)
A diagnostic trouble code (DTC) is stored if the control module detects a fault.
A malfunction that has been detected repeatedly during several driving cycles will permanently turn off the functions adaptive cruise control, collision warning, and brake assistance as well as store a diagnostic trouble code for this.
A permanently switched off system can only be reactivated by resetting DTCs in the Forward Sensing Module (FSM), Central electronic module (CEM), Brake control module (BCM) in the same operating cycle.
A driving cycle includes ignition on, that the vehicle speed goes above 20 km/h as well as ignition off.
If a fault occurs in the functions for adaptive cruise control, brake support in the event of the collision risk and functions, a fault counter counts up per function. If these counters, regardless of each other, reach a predetermined value below one and the same operating cycle, independent error flags are set in the monitoring logistics in the Central electronic module (CEM).
Permanent switching off of the functions results in diagnostic trouble codes (DTCs) being stored in the Forward Sensing Module (FSM), Brake control module (BCM), and in the Central electronic module (CEM). The diagnostic trouble codes (DTCs) must be erased from all control modules during an operating cycle to reset these error flags.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.