Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Volvo C70 AutomaticFACTORY OEM SERVICE PROCEDURE
Generator Terminals
Generator (GEN) terminals, 5 cylinder engine:
- Screw terminal #1. B+ to the battery via the starter motor
- Upper terminal #1. Not used
- Center terminal #2. To the engine control module (ECM)
- Lower terminal #3. Not used.
Generator (GEN) terminals, 4 cylinder engine:
- Screw terminal #1. B+ to the battery via the starter motor
- Upper terminal #1. To the engine control module (ECM)
- Center terminal #2. To the engine control module (ECM)
- Lower terminal #3. Reference voltage from the battery.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.