2009 Volvo XC90 R-Design, FWDFACTORY OEM SERVICE PROCEDURE

Thread Table

Values in mm  
Thread dimension  Drill - diameter  Examples of areas of use 
M6x1 6.3 Oil pump
M7x1 7.3 Sump to cylinder block, Intermediate section to cylinder block, Water pump to cylinder block
M8x1.25 8.4 Studs at the exhaust ports
M10x1.5 10.5 Intermediate section to cylinder block, Gearbox to engine
M12x1.5 12.5  
M14x1.25   Spark plugs
M14x1.5 14.2 Oil pressure switch. Oil pressure outlet engine / turbocharger unit.
M18x1.5 18.5 Oil drain plug in the sump.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.