Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Volvo XC90 R-Design, AWDFACTORY OEM SERVICE PROCEDURE
Thread Table
| Values in mm | ||
| Thread dimension | Drill - diameter | Examples of areas of use |
| M6x1 | 6.3 | Oil pump |
| M7x1 | 7.3 | Sump to cylinder block, Intermediate section to cylinder block, Water pump to cylinder block |
| M8x1.25 | 8.4 | Studs at the exhaust ports |
| M10x1.5 | 10.5 | Intermediate section to cylinder block, Gearbox to engine |
| M12x1.5 | 12.5 | |
| M14x1.25 | Spark plugs | |
| M14x1.5 | 14.2 | Oil pressure switch. Oil pressure outlet engine / turbocharger unit. |
| M18x1.5 | 18.5 | Oil drain plug in the sump. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
