2009 Volvo XC90 R-Design, AWDFACTORY OEM SERVICE PROCEDURE

Fault-Tracing Information

Condition 

Fig 1: Brake Control Module
GLL102214Courtesy of VOLVO CARS CORPORATION
  • No diagnostic trouble codes (DTCs) stored.
  • Normal battery voltage.
  • Charging system operating.
  • The fault is permanent.

Possible Source 

  • Control module not/badly connected.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.