2009 Volvo XC70 BaseFACTORY OEM SERVICE PROCEDURE

Differential Electronic Module (DEM) DTCS

DIFFERENTIAL ELECTRONIC MODULE (DEM) - DTC INDEX

DTC Volvo Code Description
P0560 DEM-P056017 System Voltage. General Electrical Failures. Circuit voltage above threshold
P0602 DEM-P060254 Powertrain Control Module Programming Error. System Programming Failures. Missing calibration
P0607 DEM-P060749 Control Module Performance. System Internal Failures. Internal electronic failure
P0634 DEM-P063468 PCM/ECM/TCM Internal Temperature Sensor Circuit. Algorithm Based Failures. Event information
P064F DEM-P064F05 Unauthorized Software/Calibration Detected. General Failure Information. System Programming Failures
P0666 DEM-P066611 PCM/ECM/TCM Internal Temperature Sensor Circuit. General Electrical Failures. Circuit short to ground
P0666 DEM-P066615 PCM/ECM/TCM Internal Temperature Sensor Circuit. General Electrical Failures. Circuit short to battery or open
P0667 DEM-P066727 PCM/ECM/TCM Internal Temperature Sensor Range/Performance. General Signal Failures. Signal rate of change above threshold
P0748 DEM-P074812 Pressure Control Solenoid A Electrical. General Electrical Failures. Circuit short to battery
P0748 DEM-P07481D Pressure Control Solenoid A Electrical. General Electrical Failures. Circuit current out of range
P0961 DEM-P096162 Pressure Control Solenoid A Control Circuit Range/Performance. Algorithm Based Failures. Signal compare failure
P1635 DEM-P163568 Tire/Axle Out of Acceptable Range. Algorithm Based Failures. Event information
P1889 DEM-P188912 Oil Pressure Pump Performance. General Electrical Failures. Circuit short to battery
P1889 DEM-P188914 Oil Pressure Pump Performance. General Electrical Failures. Circuit short to ground or open
P1889 DEM-P188918 Oil Pressure Pump Performance. General Electrical Failures. Circuit current below threshold
P1889 DEM-P188919 Oil Pressure Pump Performance. General Electrical Failures. Circuit current above threshold
P1889 DEM-P188949 Oil Pressure Pump Performance. System Internal Failures. Internal electronic failure
P1889 DEM-P18897A Oil Pressure Pump Performance. Mechanical Failures. Fluid leak or seal failure
U0001 DEM-U000100 High Speed CAN Communication Bus. General Failure Information. No sub type information
U0100 DEM-U010000 Lost Communication With Engine control module. General Failure Information. No sub type information
U0121 DEM-U012100 Lost Communication With Brake Control Module. General Failure Information. No sub type information
U0140 DEM-U014000 Lost Communication With Central electronic module. General Failure Information. No sub type information
U0300 DEM-U030000 Internal Control Module Software Incompatibility. General Failure Information. No sub type information
U0300 DEM-U030046 Internal Control Module Software Incompatibility. System Internal Failures. Calibration/parameter memory failure
U0300 DEM-U03004A Internal Control Module Software Incompatibility. System Internal Failures. Incorrect component installed
U0300 DEM-U030054 Internal Control Module Software Incompatibility. System Programming Failures. Missing calibration
U0401 DEM-U040168 Invalid Data Received from ECM/PCM A. Algorithm Based Failures. Event information
U0415 DEM-U041568 Invalid Data Received From Anti-Lock Brake System Control Module. Algorithm Based Failures. Event information
U2100 DEM-U210000 Initial Configuration Not Complete. General Failure Information. No sub type information
U2101 DEM-U210100 Control Module Configuration Incompatible. General Failure Information. No sub type information
U3003 DEM-U300362 Battery Voltage. Algorithm Based Failures. Signal compare failure
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.