There are three different in the system that define how the system is to interact in switching the system ON/off. The system is set to as default, and this should not be changed unless requested by the customer.

Short description of the various :

: The DVD device is automatically activated when the ignition is switched on.
: The DVD device is automatically set to standby mode the next time the ignition is switched on after the power has been cut.
: The DVD device is automatically activated if, in the last operating cycle, it was activated, and deactivated if, in the last operating cycle, it was deactivated, the next time the ignition is switched on.

Do as follows to open the menu for changing :

Turn on the ignition.
Activating the system for rear seat entertainment.
NOTE:
There must not be a disc in the DVD player.
Press or on the remote control depending on which DVD device is to be coded.
NOTE:
Ensure that only the DVD unit to be coded is active.
Point the remote control at the DVD device to be coded and press the following sequence: UP , RIGHT , LEFT , DOWN and then.
Select the applicable coding for the relevant DVD device by scrolling the menu with the RIGHT arrow. Then press to confirm and exit the menu.
Deactivating the system for rear seat entertainment.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Service Menu For Changing Power Mode

Use the Manual With the Right Hardware

When to See a Mechanic