Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Module
The multimedia module (MMM) has a DVD player integrated in the control module. The DVD player reads map information from a DVD. Map information is used for navigation.
The multimedia module (MMM) has an integrated accelerometer that provides information on vehicle movements, such as if the vehicle makes a turn.
The multimedia module (MMM) as inputs and outputs for:
- power supply
- ground
- GPS
- TMC
- RGB output to the high level display front (HLDF)
- MOST network
GPS
Information to the GPS unit consists of signals received from GPS satellites via the GPS antenna.
The navigation system requires at least three satellites to be able to calculate the vehicles position.
Power is supplied to the GPS unit from the multimedia module (MMM). The GPS unit is integrated with the multimedia module (MMM).
If the GPS signal is diagnosed as missing, the signal should be checked outdoors in an open area as the signal could be blocked if the vehicle is indoors and surrounding buildings could interfere with reception of GPS signals. It can take up to 12 minutes until the GPS signal has been captured and the position has been determined.
TMC
The TMC signal is sent from the antenna amplifier and is captured by the TMC receiver. The TMC signal is processed in the multimedia module (MMM) and the information is then presented on the high level display front (HLDF).
The TMC receiver is integrated with the multimedia module (MMM).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.