Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver Information Module (Dim) (2008): Function: Clock
The only function of the clock is to display the time in hours and minutes. The clock is integrated in the display in the tachometer.
Information is transmitted from the central electronic module (CEM) (4/56) to the driver information module (DIM) (5/1) via the controller area network (CAN).
The customer can adjust the time using a knob at the bottom of the driver information module (DIM). During adjustment, the driver information module (DIM) transmits the new time to the central electronic module (CEM). The central electronic module (CEM) registers the change and updates its clock accordingly.
The customer can select the way in which the time is displayed:
- 12 hour clock. The time is automatically displayed with AM or PM
- 24 hours clock.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.