Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Seat Ventilation (Option) (Only ECC)
The system for seat ventilation consists of four parts:
- a seat heating module (SHM) which controls the heater pads and the ventilation fans as well as the function for communicating with the climate control module (CCM)
- two heater pads
- a temperature sensor
- two seat fans.
The seat heating module (SHM), ventilation is located under the left and right-hand front seats. The heater pads are in the seat and backrest. The temperature sensor is in the seat. The fans, like the heater pads, are located in the seat and in the backrest. The fan speed is individually adjustable for each fan. Possible speeds are 0 to 7000 RPM.
The heater pad and temperature sensor are directly connected to the seat heating module (SHM), ventilation. The seat heating module (SHM), ventilation communicates with the climate control module (CCM) via a LIN bus.
There are diagnostics for seat heating module (SHM) ventilation left and seat heating module (SHM), ventilation right.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.