Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reduced Alarm Function
Switch for reduced alarm is located on the center console under the climate control system controls. From and including structure week 200720 activation of reduced alarm takes place via the menu in the infotainment control module (ICM). The switch is used to temporarily deactivate the vehicle tilt sensor, motion sensor and deadlock functions when the vehicle is locked. The switch has an integrated LED to indicate when the function is activated.
The function is activated during a lock cycle - from when the button is pressed and the vehicle locked until the vehicle is started. When the vehicle is started a message is displayed in the driver information module (DIM) that full protection is activated.
An example would be when a person or pet was being left in a locked vehicle. This may also be required if the car is being transported by ferry, train, or truck.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.