Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switch For Reduced Alarm (Structure Week -200746)
Switch for reduced alarm is located on the center console under the control unit for climate control. From and including structure week 200720 activation of reduced alarm takes place via the menu in the infotainment control module (ICM). The switch is used to temporarily deactivate the vehicle tilt sensor and motion sensor functions. When the function is activated the doors are not deadlocked when the vehicle is locked. The function can only be connected up to one minute after the ignition has been switched off. If a longer time has passed the ignition must be turned to position I and back to 0 before the function can be activated.
The switch has an integrated LED to indicate when the function is activated. A message is displayed in the display in the driver information module (DIM).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
