Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pedal Position Sensor 7/124: General
Type
Slide potentiometer.
The sensor is actuated by the brake pedal pushrod
characteristic
Resistance between terminals #2 and #3 should be approx. 0.5 kΩ when the brake pedal is not actuated. Resistance should increase when the brake pedal is depressed.
Resistance between terminals #3 and #1 should be approx. 2.5 kΩ when the brake pedal is not actuated. Resistance should decrease when the brake pedal is depressed.
Upon ignition, voltage should be:
0 mm ≈ 0.15 V (brake pedal not actuated)
38.5 mm ≈ 4.75 V (brake pedal depressed)
Other information
None.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.