2009 Volvo V70FACTORY OEM SERVICE PROCEDURE

The Controller Area Network (Can): Notes

CAN (Controller Area Network) is a standardized system for multiplex-communication. Multiplex communication means that several control modules can use the same cables for communication without traffic from one control module interfering with traffic from another.

Volvo has developed a new standard for multiplex communication - VOLCANO. VOLCANO is a development of CAN and uses real time operation and prioritization. The description of prioritization is based on VOLCANO but is designated CAN.

The standard for Control area network (CAN) specifies:Β 

  • That two cables should be used (CAN H and CAN L)
  • Which voltage levels should be used
  • What a message should look like
  • How transfer errors should be handled.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.