2009 Volvo V70FACTORY OEM SERVICE PROCEDURE

Rain Sensor

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 10 CD Changer Connector Terminals
GLL104029Courtesy of VOLVO CARS CORPORATION

Connector A, terminals #A1-#A5

U = DC in volts (V).

Ubat = battery voltage in volts (V).

Ulow = voltage near 0 V.

Terminal, control module  Signal type  Ignition off  Ignition on  Miscellaneous 
#A1 Serial communication - - Data signal
#A2 Ground Ulow Ulow -
#A3 Power supply Ubat /0 V Ubat /0 V -
#A4 Windscreen wiper position signal - Ubat /0V When the windscreen wipers are in the parked position, U must be Ubat . When the windscreen wipers are operating U must be 0 V (grounded).
#A5 Not used - - -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.