2009 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Motors

MOTORS LOCATION

Component Location
Auxiliary Heater Fuel Pump (6/35) Right rear of vehicle. See Figure.
Back Massage Pump (Left/Right) Left rear of luggage compartment. See Figure.
Backrest Angle Driver Seat Motor (6/16) In driver's seat back. See Figure.
Backrest Angle Passenger Seat Motor (6/64) In passenger seat back. See Figure.
Central Locking Lock Motor (Left Front) (6/36) Rear of left front door. See Figure.
Central Locking Lock Motor (Left Rear) (6/57) Rear of left rear door. See Figure.
Central Locking Lock Motor (Right Front) (6/55) Rear of right front door. See Figure.
Central Locking Lock Motor (Right Rear) (6/56) Rear right rear door. See Figure.
Coolant Pump (6/73) Center rear of engine compartment. See Figure.
Defroster Damper Motor Module (DMM) (6/102) On HVAC assembly. See Figure.
Electronic Throttle Actuator (6/120) On throttle body. See Figure.
Floor/Ventilation Damper Motor Module (DMM) (6/103) Behind center of dash, on right side of HVAC unit. See Figure.
Forward/Backward Driver Seat Motor (6/19) In driver seat. See Figure.
Forward/Backward Passenger Seat Motor (6/20) In front passenger seat. See Figure.
Fuel Filler Cover Lock Motor (6/37) At right side of trunk, near fuel filler. See Figure.
Fuel Leakage Control Pump (6/67) Under rear of vehicle, forward of fuel tank. See Figure.
Fuel Pump (6/33) At top of fuel tank. See Figure.
Headlight High Pressure Washer Motor (6/104) Bottom of washer reservoir. See Figure.
Headlight Level Adjustment Motor (Left/Right) (6/38-6/39) Behind respective headlight assemblies. See Figure.
Intake Manifold Lower Actuating Motor (6/140) On intake manifold. See Figure.
Intake Manifold Upper Actuating Motor (6/139) On intake manifold. See Figure.
Passenger Compartment Fan Motor (6/28) Behind right side of dash, in right end of HVAC unit. See Figure.
Power Door Mirror (Left) (6/62) In driver's door mirror. See Figure.
Power Door Mirror (Right) (6/63) In front passenger door mirror. See Figure.
Power Window Motor (Left Front) (6/58) In left front door. See Figure.
Power Window Motor (Left Rear) (6/59) In left rear door. See Figure.
Power Window Motor (Right Front) (6/60) In right front door. See Figure.
Power Window Motor (Right Rear) (6/61) In right rear door. See Figure.
Rear Brake Disc Lock Motor (Left/Right) (6/146, 6/147) At respective rear brake assembly. See Figure.
Recirculation Damper Motor Module (DMM) (6/48) Bottom of damper motor, under right side of dash. See Figure.
Starter Motor (6/25) Left side of engine. See Figure.
Swirl Throttle Regulator Motor (6/118) Right rear of engine compartment. See Figure.
Telescopic Nozzle (Left/Right) (6/144, 6/145) Under respective headlight assembly. See Figure.
Temperature Damper Motor Module (DMM) (Left) (6/95) On HVAC assembly. See Figure.
Temperature Damper Motor Module (DMM) (Right) (6/96) On HVAC assembly. See Figure.
Trunk Lid Central Locking Motor (6/8) Center rear of trunk lid. See Figure.
Turbo Regulator Motor (6/143) On turbo. See Figure.
Up/Down Front Edge Driver Seat Motor (6/17) In driver's seat bottom. See Figure.
Up/Down Front Edge Passenger Seat Motor (6/65) In passenger seat bottom. See Figure.
Up/Down Rear Edge Driver Seat Motor (6/18) In driver's seat bottom. See Figure.
Up/Down Rear Edge Passenger Seat Motor (6/66) In passenger seat bottom. See Figure.
Vacuum Pump (6/114) At left rear of engine. See Figure.
Washer Motor (6/127) Bottom of washer fluid reservoir. See Figure.
Wiper Motor Module (WMM) (6/1) At left rear of engine compartment. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.