Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Replacing A Component
The control module has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the Forward Sensing Module (FSM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the problem returns, load the Forward Sensing Module (FSM) with new software.
If downloading of new software did not help, replace the Forward Sensing Module (FSM).
Remedy as necessary.
Other information
- Continue
Refer to INFORMATION
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
