2008 Volvo S60 Base, FWDFACTORY OEM SERVICE PROCEDURE

Checking control module function: Verification

HINT: After carrying out the repair, check that the fault has been remedied.Β 

Fig 1: Identifying Ignition Switch ON Position
GLL101051Courtesy of VOLVO CARS OF NORTH AMERICA.
  • Ignition off.
  • Reconnect connectors, reinstall components.
  • Ignition on.

    When the ignition is switched on the control module lights the ABS warning lamp. Check that the warning lamp goes out after approximately 2 seconds.

    NOTE:

    The warning lamp will not go out if a fault has been stored in the control module.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.