Door Module (Power Windows, Power Mirrors, Child Locks, Central Locking), Front Doors

Door module (power windows, power mirrors, child locks, central locking), front doors

Replacing the driver door module (DDM) and passenger door module (PDM)

Preparations

Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity which is required to order the correct software.

Always check that the control module and control module box connectors do not have bent or damaged terminals or socket/sleeves. This may have been the cause of the fault.

Removing the control module
This method of removal applies to both the driver door module (DDM) and the passenger door module (PDM).




The illustration shows the driver door module (DDM).
- Ignition off
- Remove the door panel
- Remove the nut and screw holding the door module
- Disconnect the connectors
- Pry up the rear edge of the door module. Pull the door module backwards and upwards. Remove the door module from its mounting on the door panel
- Press up the door module.
- Remove the upper panel.

Check
Check that the control module's connectors are intact.

Installing the control module
This method of installation applies to both the driver door module (DDM) and the passenger door module (PDM).
- Position the door module in the hole on the door panel.
Check that the lower mounting for the door module is correctly located in the support on the door panel
- Press the door module into place
- Connect the connectors
- Install the nut and screw
- Install the door panel.

Ordering software
Order software for the driver door module (DDM) according to the table below.





Order software for the passenger door module (PDM) according to the table below.






Finishing
Initialize the window position in the communication input

Removing the upper panel




The illustration shows the driver door module (DDM).
- Remove the control module, see instruction Removing the control module.
- Disconnect the catches. Lift the upper panel from the control module.

Installing the upper panel
In reverse order.