Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Volvo S60 Base, AWDFACTORY OEM SERVICE PROCEDURE
Steering Angle Sensor (SAS) DTCS
STEERING ANGLE SENSOR (SAS) DTC INDEX
| Volvo Code | Description |
|---|---|
| SAS-0001 | Control module. Faulty voltage |
| SAS-0002 | Control module. Internal fault |
| SAS-0003 | Steering wheel angle sensor. Signal outside its permitted range |
| SAS-0004 | Steering wheel angle sensor. Signal outside its permitted range |
| SAS-0005 | Control module. Internal fault |
| SAS-0006 | Control module. Internal fault |
| SAS-0007 | Control module. Internal fault |
| SAS-0008 | Steering wheel angle sensor. Internal fault |
| SAS-0009 | Control module. Internal fault |
| SAS-000A | Steering wheel angle sensor. Internal fault |
| SAS-000B | Control module. Internal fault |
| SAS-000C | Control module. Internal fault |
| SAS-000E | Steering wheel angle sensor. Internal fault |
| SAS-000F | Steering wheel angle sensor. Internal fault |
| SAS-0010 | Steering wheel angle sensor. Internal fault |
| SAS-0011 | Steering wheel angle sensor. Internal fault |
| SAS-0014 | Steering wheel angle sensor. Internal fault |
| SAS-0015 | Steering wheel angle sensor. Internal fault |
| SAS-0016 | Control module. Communication fault |
| SAS-0017 | Control module. Faulty signal |
| SAS-0018 | Control module. Signal missing |
| SAS-0019 | Control module. Internal fault |
| SAS-E000 | Control module communication. Faulty communication |
| SAS-E003 | Configuration fault |
| SAS-E010 | Control module. Voltage too low |
| SAS-XXXX | Unknown diagnostic trouble code (DTC) for the current control module version |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.