Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Volvo C70 AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G31/3 | At left strut tower. See Figure. |
| G31/4 | Front of battery. See Figure. |
| G31/6 | At left kick panel. See Figure. |
| G31/10 | At right kick panel. See Figure. |
| G31/11 | Left rear of vehicle. See Figure. |
| G31/12 | Right rear of vehicle. See Figure. |
| G31/52 | At left front strut tower. See Figure. |
| G31/66 | Below driver's seat, near rocker panel. See Figure. |
| G31/67 | Below passenger's seat, near rocker panel. See Figure. |
| G31/80 | On left front strut tower. See Figure. |
| G31/83 | At left kick panel. See Figure. |
| G31/84 | At right kick panel. See Figure. |
| G31/88 | At top of engine, near spark plugs. See Figure. |
| G31/89 | At top of engine, near spark plugs. See Figure. |
| G31/102 | On front member. See Figure. |
| G31/110 | On right front strut tower. See Figure. |
| G31/112 | On right front strut tower. See Figure. |
| G31/114 | On left front strut tower. See Figure. |
| G31/115 | At left kick panel. See Figure. |
| G31/116 | At right kick panel. See Figure. |
| G31/119 | On left front strut tower. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
