Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switch For Load Assistance
The switch for load assistance is located on the right-hand side on the sill in the cargo compartment and is directly connected to the Convertible Roof Module (CRM). The switch controls a function called load assistance.
For operation, press the switch:
- once to activate movement
- once more to stop (if the limit position has not already been reached)
- a final time to reset the roof sections.
Operation is automatic and the switch must not be held depressed.
Functions of the load assistance switch:
- to raise the stored roof sections
- to lower the stored roof sections
- to stop operation of the load assistance.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.