2005 Volvo V50 Base, 2.4 39FACTORY OEM SERVICE PROCEDURE

Transmission Input Speed Sensor

The value indicates the input speed. The speed can be generated with the engine idling and the gear selector in P/N position. If the gear selector is in any other position, a gear is engaged and the transmission input shaft is connected to the output shaft and an RPM will not be indicated until the car is driven. Depending on slippage in the torque converter the transmission speed and the engine speed will differ when the lock-up function is not engaged. With lock-up engaged the transmission speed should be the same as engine speed (RPM).

Measurement range: 0 - 10000 rpm.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.