Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reading Off Input And Output Signals
This function can be used to continuously read off the values and status for the accessory electronic module (AEM) input and output signals.
The following parameters can be read off:
- Voltage supply to the accessory electronic module (AEM)
- Rheostat signal, the strength is given as a percentage
- Speed signal, given as a frequency where 512 is the highest frequency
- Voltage level of the signal to the relay, engine block heater
- Voltage level of the signal to the remote start module
- Voltage supply to the remote start unit
- Voltage level of alarm signals P0, P1, S0 and S1
- Voltage level of the signal to telemute
- Voltage level of the signal from telemute
- Power supply to the aerial amplifier.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.