Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Description Of Frozen Values (B6324S): Explanation
Frozen values are parameter values that are stored when a diagnostic trouble code (DTC) is stored.
Not all parameters can be read out for all diagnostic trouble codes. The parameter values can only be read if they can provide additional information on the prevailing conditions when the code was generated.
HINT: The engine cylinders are counted starting from the cylinder furthest from the flywheel (right-hand side of the vehicle in the direction of travel)
HINT: Bank 1 (cylinder row nearest the front): cylinders 1, 3, 5 and 7.
HINT: Bank 2 (cylinder row furthest to the rear, nearest the passenger compartment): cylinders 2, 4, 6, and 8.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.