Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Selector switch: General
The cruise control selector switch is located on the turning indicator stalk. To activate cruise control vehicle speed must be above 35 km/h, the switch must be ON and the SET button must be pressed in.
When the system has been engaged vehicle speed can be adjusted up or down by pressing the + or - SET button. Every time the SET button is pressed the vehicle speed setting changes by 1.6 km/h (1 mph). If the control module is switched off (by pressing the brake/clutch pedals, the ON/OFF button or by moving the gear selector from D to N) that latest vehicle speed setting is stored in memory until the ignition is switched off. This vehicle speed can be restored by moving the ON/OFF button to the RESUME position.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.