Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Selector switch: General
The cruise control selector switch is located on the turning indicator stalk. To activate cruise control vehicle speed must be above 35 km/h, the switch must be ON and the SET button must be pressed in.
When the system has been engaged vehicle speed can be adjusted up or down by pressing the + or - SET button. Every time the SET button is pressed the vehicle speed setting changes by 1.6 km/h (1 mph). If the control module is switched off (by pressing the brake/clutch pedals, the ON/OFF button or by moving the gear selector from D to N) that latest vehicle speed setting is stored in memory until the ignition is switched off. This vehicle speed can be restored by moving the ON/OFF button to the RESUME position.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.