2002 Volvo V70 XCFACTORY OEM SERVICE PROCEDURE

Rear window lift mechanisms

Fig 1: Identifying Rear Window Lift Mechanisms
GLL106026Courtesy of VOLVO CARS OF NORTH AMERICA.

The rear side windows are operated by motors in the doors. The switches for operating the windows are in the door panels. The windows can also be operated from the driver's door module (DDM).

The function is controlled by five relays inside the rear electronic module (REM). Depending on whether the control switch is moved up or down, the relays are activated to carry out the requested operation.

Two relays guide the window up on the right and left-hand sides. Two other relays lower the window. A further relay controls the power supply.

When operated from the driver's position, information is transmitted via the controller area network (CAN) from the driver's door module (DDM) to the rear electronic module (REM) which sends out signals to the relays.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.