Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Combined high and low beam
Reflector, left-hand headlamp
The illustration is a principle sketch showing the different segments of the moving reflector.
The reflector has a complex design where different segments are used depending on whether in high or low beam position.
The reflector is adjustable and can be moved between two fixed points.
- The reflector is moved 2 mm axially in relation to the bulb
- The direction of the movement means that position of reflector is also moved slightly vertically.
The bulb is fixed.
The headlamp lens is clear.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
