Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clutch pedal sensor (manual transmissions only)
The clutch pedal sensor provides the Engine Control Module (ECM) with information about the position of the clutch pedal.
This information is used by the control module to switch off the cruise control.
The sensor signal is also used by the control module to prevent engine start if the clutch pedal is not pressed (certain markets).
The sensor consists of a sliding potentiometer which is supplied with power by the control module (signal) and which is grounded in the control module.
The resistance in the sensor reduces as pressure increases on the clutch pedal.
The engine control module (ECM) can diagnose the clutch pedal sensor. The status (position) of the sensor can be read using VIDA.
The sensor is on the pedal box by the clutch pedal.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.