Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switches in the lock units
A switch is fitted in each lock unit for the doors and trunk lid/tailgate. Vehicles equipped with an alarm have a switch in the hood lock. The switches are closed when the respective door or hatch is closed. There is no switch for the fuel tank filler cover.
At regular intervals, the rear electronic module (REM) checks if the switches are closed when the alarm is activated. If the rear electronic module (REM) detects that a switch opens, the alarm is triggered.
If the rear electronic module (REM) detects a switch that is not closed when central locking is engaged and alarm activation is to be carried out, the inclination sensor module (ISM) and the mass movement sensor module (MMS) will not be activated. Similarly, signals from a switch that was not closed during activation will be disregarded. No flash is given in acknowledgment before all switches are closed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
