2002 Volvo V70 XCFACTORY OEM SERVICE PROCEDURE

Control valve/axial solenoid

Fig 1: Control Valve/Axial Solenoid
GLL106597Courtesy of VOLVO CARS OF NORTH AMERICA.

The control valve/axial solenoid are in the coupling unit for the active on demand coupling (AOC).

The axial solenoid receives a constant pulse width modulated (PWM) signal from the control module. The control signal from the control module is used by the solenoid to change the position of the control valve. This regulates the pressure to the operating piston in the multi-plate clutch.

Four wheel drive is disabled if there is a fault in the control valve/axial solenoid.

There are diagnostics for the control valve/axial solenoid.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.