2002 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE

Central Electronic Module

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

The central electronic module (4/56) is the main control module for alarm functionality. The central electronic module determines how the alarm should be activated, deactivated or deployed by receiving information on the Controller Area Network (CAN) from other control modules and via the directly connected signal cables from the components.

Signal cables are directly connected to the central electronic module from:

  • Switch in the lock units in all doors (3/74-77), open/closed
  • Switch in the lock units in the rear side doors (3/76-77), locked / unlocked
  • Switch in the lock unit trunk lid (3/78), open/closed. (S60/S80)
  • Switch hood (3/62), open/closed

The central electronic module is controlled via a direct cable:

  • All turn signal lamps.

For information received and transmitted via the controller area network for alarm functionality see the relevant control module as follows.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.