2002 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE

System Overview: Signals

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

The chart below summarizes the input and output signals to and from the differential electronic module. The illustration below displays the same information with the Volvo part numbers.

Input signals Output signals
Directly connected:  Directly connected:  (power supply unless otherwise stated)
Temperature sensor Electric feed pump
  Stepper motor
   
Via Control Area Network (CAN):  Via Control Area Network (CAN): 
Central electronic module (4/56), parking brake switch status, ignition key position and back up signal BCM (4/16), clutch status
BCM (4/16), wheel speed from the wheel speed sensors and status signal (to open the clutch at stability control).  
Engine control module (ECM) (4/46), provides information about, engine speed (RPM), torque, accelerator pedal (AP) position and the stop lamp switch status.  
 
Fig 1: Identifying Differential Electronic Module DEM Signals
GLL106551Courtesy of VOLVO CARS OF NORTH AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.