Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE
Transferring Components
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
Transfer:
- the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm . Angle-tighten 90° . Use bevel protractor 9512050 . Tighten the rear screw. Tighten to 105 Nm . Angle-tighten 90°
- the anti-roll bar. Tighten to 60 Nm
- the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm . Angle-tighten 60°
- the exhaust mounting bracket. Tighten to 50 Nm
- the shock absorber Tighten to 50 Nm
- lower torque rod. Tighten to 65 Nm . Angle-tighten 90° .
Install new pipe/hose holders.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
