2002 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE

Installing Removed Components

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

Install: 

  • the rubber mountings for the exhaust pipe
  • SIPS (side impact protection system) member
  • the four screws for the SIPS (side impact protection system) member. Tighten to 24 Nm  .

Install the four nuts and the screw holding the steering gear. Use new nuts and a new screw. Tighten to 50 Nm  .

Clip the cable in position.

Install: 

  • the ball joints. Use new nuts. Tighten to 80 Nm  . Counterhold using a Torx wrench so that the ball joint boot is not damaged
  • the anti-roll bar links. Use new nuts. Tighten to 50 Nm  . Counterhold using a Torx wrench so that the boot is not damaged.

Install: 

  • the lower torque rod. Tighten the two screws. Tighten to 10 Nm 
  • the oil pipe for the steering gear from the snap fasteners along the sub-frame
  • the screw clip for the steering gear return line
  • any fuel line for engine block heater
  • the screw for the cable duct
  • the screw for the ground lead.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.