2002 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE

Reading Off Input And Output Signals

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

This function can be used to continuously read off the values and status of the control module's input and output signals.

The following parameters can be read off:

  • The number of remote controls
  • The number of the remote control
    NOTE:

    One of the remote control buttons must be activated when reading off.

  • The activated buttons on the remote control
    NOTE:

    One of the remote control buttons must be activated when reading off.

  • Power supply to mass movement sensor (MMS), status
    NOTE:

    Listed as On or Off. The mass movement sensor module (MMS) is supplied with voltage (On) when the alarm is activated and the sensors are connected.

  • Alarm status
    NOTE:

    Indicates the alarm setting and alarm sensor setting. Six states can occur:

    Alarm status 1: Not activated and not deployed, connected sensors.

    Alarm status 2: Activated and not deployed, connected sensors.

    Alarm status 3: Activated and not deployed, disconnected sensors.

    Alarm status 4: Activated and deployed, connected sensors.

    Alarm status 5: Activated and deployed, disconnected sensors.

    Alarm status 6: Not activated and not deployed, disconnected sensors.

  • Front left reading lamp, status
  • The switch for the front left reading lamp
  • Front right reading lamp, status
  • Switch for the front right reading lamp
  • Rear left reading lamp, status
  • The switch for the rear left reading lamp
  • Rear right reading lamp, status
  • The switch for the rear right reading lamp
  • The switch for the general lighting
  • Extended X-supply, status
    NOTE:

    X-supply supplies power to the sunroof, mirror lamps and rain sensor module (RSM). X-supply is active when the controller area network (CAN) is active, and for a short time after the controller area network (CAN) is no longer active. This time varies and depends on a number of parameters.

  • Local lighting, status
  • Cargo compartment lighting, status
  • Supply voltage, sun roof
    NOTE:

    The following parameters for the sun roof are read off from a separate vehicle communication input for the upper electronic module (UEM).

  • Button activation, forward
  • Button activation, backward
  • Button activation, tilt
  • Button activation, auto
  • Motor, forward
  • Motor, backward.
  • NOTE:

    The following parameters for tire pressure monitoring can only be read off on vehicles with TPMS.

  • Last received sensor ID
  • Last stored tire pressure
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.