Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Gear Position Indicator
The gear position indicator is integrated with the Transmission Control Module (TCM) as one unit.
The gear position indicator informs the Transmission Control Module (TCM) on the gear selected, and whether reverse gear is engaged to light the reversing lamp. The gear position indicator contains a permanent magnet and a linear Hall sensor. The gear position indicator creates a signal voltage of between 0 and 5 V which equates to current gear selector lever position.
The gear position indicator can be diagnosed.
Voltage Level For The Different Gear Positions
P ≈ 0,65 V
R ≈ 1,64 V
N ≈ 1,12 V
D ≈ 2,49 V
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.