2002 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE

Changing The Driving Mode (R Line)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

There are different driving modes in the suspension module (SUM). These driving modes are changed via the keypad (ACTIVE CHASSIS SETTINGS) on the dashboard. Information about the driving mode selected by the driver is transmitted from the control module to the keypad via directly connected cables.

There is a choice of three different driving modes. The control module always remembers the driving mode which was selected last and stores it after each new operating cycle. If the "ADVANCED" program is active when the engine is stopped, the system will start in "SPORT" mode the next time.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.