2002 Volvo S40FACTORY OEM SERVICE PROCEDURE

Boost Pressure Control Valve

  1. Remove turbocharger control valve from air cleaner housing. Disconnect Yellow-marked hose from turbocharger control valve. Connect Manometer (999-5230) and Pressure Regulator (999-5766) to disconnected hose. Connect air supply to pressure regulator. See Fig 1.
  2. Remove heat shield from exhaust manifold. Turn set screw on pressure regulator clockwise until proper pressure is reached. See BOOST PRESSURE SPECIFICATIONΒ  table. Use a vernier caliper to measure stroke of boost pressure control valve lever. Value represents opening of boost pressure control valve. Ensure valve is completely closed with lever in resting position. See Fig 2.
    CAUTION: DO NOT twist boost pressure control lever while adjusting. This may tear internal membrane and damage boost pressure control valve. Lever must be adjusted while mounted on servo.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.