Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Volvo C70 2D Coupe, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel, Ignition And Control Systems - Specifications (Coupe)
- Car Communication Information (B5234T3; 1999-2002)
- Description Of Activation Components/Functions
- Description of parameters
- Explanation
- Engine speed
- Engine coolant temperature (ECT)
- Intake air temperature
- Outside temperature Β°C
- Atmospheric pressure
- Boost pressure
- Ignition advance
- Air mass
- Air mass, correction value
- Battery voltage
- Power supply, 5 V
- Accelerator pedal, analog
- Accelerator pedal, PWM
- Accelerator pedal, PWM (via ETM)
- Throttle, position
- Leakage flow across throttle
- Clutch pedal position
- Clutch pedal position sensor
- Brake pedal position, volts
- Stop lamp switch
- A/C pressure
- Air conditioning (A/C) compressor, active
- Turbo control valve
- Canister purge (CP) valve
- Reset valve camshaft
- Camshaft shift angle
- Camshaft shift angle, desired value
- Camshaft adaptation, flank x
- Tank pressure
- EVAP canister shut-off valve
- Injection period, bank x
- Short-term fuel trim, bank x
- Lambda adaptation, bank x, idling speed
- Lambda adaptation, bank x, lower partial load
- Lambda adaptation, bank x, upper partial load
- Fuel trim, bank x
- Front heated oxygen sensor, bank x
- Rear heated oxygen sensor, bank x
- Fuel pump, relay
- Speed
- Electric cooling fan, speed 1
- Electric cooling fan, speed 2
- Cruise control, resume
- Cruise control, set+
- Cruise control, SET-
- Boost pressure (actual value)
- Boost pressure (desired value)
- Car Communication Information (B5244T; 2000-2001)
- Car Communication Information (B5254T; 1999)
- Specifications (B5234T3; 1999-2002)
- Specifications (B5254T; 1999)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
