Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Volvo C70 2D Coupe, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Control Module (ECM), Fuel Pump - Removal & Installation (Coupe)
- Engine Fuel
- Fuel Pump Unit, Replacing
- Notes
- Safety
- Preparation
- Removing the luggage compartment floor
- Unplugging the connectors
- Detaching the filler pipe
- Disconnecting the rear wheels
- Disconnecting the fuel tank EVAP lines
- Removing the protective covers in front of fuel tank
- Removing the exhaust pipe
- Detaching the longitudinal stay mountings
- Removing the hand brake cable
- Removing the propeller shaft
- Standard bolts for front and rear CV joints and balancer bolt for rear CV joint
- Lowering the torque tube
- Removing the rear suspension assembly
- Fitting the fuel pump units
- Fitting the rear suspension assembly
- Fitting the fuel lines
- Removing Fuel Line From Fuel Pump
- Fitting the fuel lines to the clips
- Fitting the hand brake cable
- Raising the rear suspension with fuel tank
- Fitting the retaining bolts for the rear axle member.
- Tightening the tank strap attachments
- Fitting the fuel tank EVAP lines
- Fitting the propeller shaft and driver
- Fitting the longitudinal stay mountings and jack attachments
- Fitting the exhaust pipe
- Fitting the filler pipe
- Fitting the hatches and connections to the tank fitting
- Positioning the luggage compartment floor mountings
- Fitting the rear wheels
- Fuel Pump Unit, Replacing
- Engine Control Module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
