Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE
Rear Adjustment
- Loosen the inner nut on the tie rod. Adjust the toe-in to specification. See WHEEL ALIGNMENT SPECIFICATIONS . Use the eccentric bolt. See Fig 1 . Tighten the nuts slightly.
- Check the thrust angle. If it is outside the value given, loosen the nuts and adjust the toe-in again. Tighten the nut to specification. See TORQUE SPECIFICATIONS . Check the toe-in again. Check the thrust angle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.